E-Coating Racks

E-Coating Racks

Endura E-Coating racks are accurately manufactured using precision computer controlled equipment and racks are available in quantities ranging from one to thousands. All racks are custom designed and manufactured to your specifications.

Capabilities

Reduce Part Loss

Endura tension racks are design to hold parts securely. Parts can't "float off" the rack during cleaning.

Even customers using spray washing equipment are amazed at how securely Endura racks hold parts in place.

Reduces Light Coats

E-Coating rack design is proven.

Many painters and e-coaters have an unacceptable percentage of light coats. Endura racks are designed to dramatically reduce light coats.

Hook racks and many tension racks use round wire to hold the part. With hook racks, only the part weight of the part is pressing the part into contact with the rack. As small parts are light, this grounding system is not reliable to say the least.

Endura racks are made of a special flat spring steel punched out or laser cut on computer controlled equipment. Rack edges are intentionally sharp. As a part is mounted on the tension fingers, the sharp edges of the rack are pressed into contact with the part. This design has been consistently proven to provide a superior ground to the part.

Improves Finish Quality

A superior ground means a superior finish with minimal light coat profit loss.

Customers today want quality and without a good electrical ground, a consistent high quality finish is impossible.

Automation

E-Coating racks assure maximum efficiency.

Endura tension racks are designed to be used with FasTrack racking and unracking equipment. Using FasTrack equipment, and Endura tension racks, customers can dramatically increase racking and unracking efficiency, and virtually eliminate racking and unracking carpal tunnel issues.

Video: Manual Racking Machine

Features

Custom Rack Configurations

E-Coating racks assure maximum quality.

Endura painting and e-coating tension racks are made to optimize production on your finishing line.

Rack length, pin spacing and profile, rack material thickness, special drainage considerations, single, two or four sided configurations are factored to assure maximum efficiency, quality and productivity.

The level of flexibility and control which Endura racks provide is unavailable using hook racks.

Custom Rack Ends

Standard or custom rack ends are available on Endura racks. Rack ends are designed to work with your existing rack frames or conveyors.

Dimpled Racks

E-Coating racks, the dimpled version.

Dimpled racks dramatically reduce the amount of liquid which can be trapped in the rack.

Reducing trapped liquid significantly reduces chemical "carry over" between cleaning tanks.

This feature also virtually eliminates "spatter" problems which are caused when trapped liquid cooks out of the rack during oven drying and/or curing.

Dimpled racks cost a little more than a standard rack but customers agree the new dimpled racks are well worth the small additional expense.

Literature

Videos

Pictures

Important

Customers who burn off painting and/or e-coating racks must ensure the burn off temperature does not remove the temper from the racks. Damage to racks caused by excessive burn off temperature is not covered under warranty.